![]() You have your very own backlight to show off. If there’s any overlap of LED, you can cover it up with the insulation tape too. You can also tape the adapter to the back, so you don’t have any visible wires. When you’ve finally stuck the light, you can use regular black insulation tape to tape over the exposed contacts if you reach around your TV to plug in stuff often. By putting it in a line, you get a dimmer light, but you get light distributed evenly around your TV. Remove the 3M tape and start sticking the LEDs in whatever way you want it to be around your TV. However, if you are doing the latter, make sure not to interchange the poles when you connect the wires into the socket. Now that you have your LED strips and connector, you can connect the + and - wires to a plug, or map them to a switch if you want. You can save some money if you have an adapter of your own and soldering skills. This is done by the electric shop themselves. Usually the LED will be cut at the connector nodes, but you will need a soldering iron to stick the adapter on to it. Once you get the wire, you have to purchase a 12V adapter with it. Note: Double check that the strip has a 3M tape on the other side. Usually it comes in singular colours, so you can get white light, warm white, yellow, red and other single colours. Whichever way you want it, just make sure you measure your TV first. If you want a slightly lower light radius, you can just put one-metre strip in a line, somewhere at the centre of the TV. They cost less than Rs 70 per metre, and a metre and a half would suffice for, let’s say, a 40-inch TV to go all round. Method 1: Budget The simplest method is to go out to the hardware shop and get LED strips. Here are four ways you can add ambient light to your life, for all types of budgets and all types of purposes. READ ALSO: 8 tips to save eyes from computer vision syndrome Having ambient light around your TV throws an even hue, allowing your eyes to remain focused without that strain. This causes eye-strain, as the pupil is adjusting at microlevels, while your head is moving in reaction to the movie you’re watching. When you watch in the dark, you have one rectangle of bright LED lights, but the rest is dark. When the light is bright, your pupils will narrow in about 5 seconds flat however, to adjust to the dark, the pupils have to increase in size to let in more light, but it happens very slowly, taking about 5 minutes. Why ambient lighting ? Why do people say watching in the dark is bad for your eyes? Well, keeping it simple, the pupil of your eye increases or decreases in size to let certain amounts of light in. That’s where ambient backlight comes in, which not only reduces eyestrain but also adds a supercool accent lighting to your setup. However, these sessions are also a marathon strain for your eyes, especially for those with smaller TVs. Nights are always the best time to curl up on your couch for movie marathons or long gaming sessions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |